2 In 1 AHD CVBS Analog HD CCTV Camera UTC Controller for Remote Control UP The Coax Video Surveillance BNC Coaxial Cable OSD Menu

Notice:

1. This UTC controller only supports AHD and CVBS analog cameras, NOT CVI/TVI cameras, though the LCD may display other names.

2. Please ensure your camera is UTC control supported (camera boards with UTC TX chip like RJ103, IX528, etc.) before you order or apply the UTC controller. Usually, default output cameras don't have UTC control IC because extra cost is required for UTC version.

3. Please ensure your camera supports AHD/CVBS signal switch if you need to use the switch function.

4. Please ensure your camera comes with OSD menu. Camera with OSD cable DOES NOT mean the camera supports UTC control. They are different.

5. There is no user manual provided with the UTC controller. The operation is subject to your camera module and OSD cable control, SAME AS your camera OSD cable controller use. Thus, please consult your camera supplier about the OSD operation instructions of the camera. If you are not professional in security cameras or you are not familiar with UTC control, we don't suggest you place order, or else, we may both have trouble in UTC controller use.

Description:

Up The Coax (UTC) technology - this new function allows the user to control the camera's OSD settings at the DVR end rather than at the camera end. This is INSTALLATION HEAVEN! The previous technology had an OSD Remote Control attached to the camera wire, which meant the OSD settings could only be controlled at the camera end. This was a real downside to the whole concept as once the camera was installed the user could only make future adjustments to the picture and activate other functions by getting to the camera. As all installers would know this was a real nightmare! Well, the solution is here! Now installers can control ALL UTC enabled cameras with the joy of a SINGLE UTC Controller, YES a single UTC Controller!